Cabletron Systems CSX1000 - Manual (Page 452)

USER’S GUIDE
452 CyberSWITCH
Frame Relay PVC connection down: Slot=, Port=
The Frame Relay PVC connection is down for the indicated slot and port number.
Frame Relay PVC connection up: Slot=, Port=, DLCI=
The Frame Relay PVC connection is up for the indicated slot, port, and DLCI index.
FrBufFree: error during free
The indicated error occurred during an attempt to free a buffer to its memory pool. Contact your
Distributor or Customer Support.
FrUtl: No registered device for DLCI
A frame was received on the PVC associated with the indicated DLCI, and no Frame Relay Service
Device had (as yet) registered to use this PVC.
IePvcStatus: Received Status Report for unknown PVC #
The indicated unknown DLCI was indicated in a STATUS message received from the network. This
DLCI number is entered in the “unknown DLCI” list and can be displayed via the FR LMI system
console command.
Incoming call from , Slot=, Port=, Chan= Rejected by BW
Reservation
A bandwidth reservation message. Indicates that a call has come in from the indicated device, on a
line that is not in this device’s profile. The call will be disconnected. If you see this message often,
check the remote device’s configuration to prevent wasted calls.
Initial TDM Clock Master:
The external line indicated has been selected as the master clock source.
Initializing...
Displays the current state of the system (initialization).
Installing File Set into Flash Memory
The file set, received via X-Modem, has successfully passed its verification tests and is now being
written into the Flash File System.
Insufficient space for buffer pool creation
There is not enough system memory to proceed with the creation of the requested size buffer pool.
Contact your Distributor or Customer Support.
Interrupt fault on WAN Adapter in Slot
The interrupt jumper for the WAN Adapter in the specified slot is missing or misplaced.
Invalid caller number: -
The incoming call security feature is enabled and a call was received from an unknown remote site,
therefore the call was disconnected. If the call was from a valid remote site, the device list must be
updated to include the remote site's phone number.
Invalid Call_ID in HOST_CALL_CONNECTED
Invalid Call_ID in HOST_CALL_DISCONNECT
The above Robbed Bit Signaling messages indicate that the system software sent a message to the
RBS state machine that the state machine was unable to recognize or the information was incorrect.
If this message is displayed in the log messages, contact your Distributor or Customer Support.