Cabletron Systems CSX1000 User Manual
Page 471

Workgroup Remote Access Switch 471
S
YSTEM
M
ESSAGES
System Message Summary
Resmem_gettotal: Enabled size
ResMem_Malloc failure for subsystem
(size=
ResMem_Malloc Size
ra=
ResMem_Malloc Device not registered (ra=
ResMem_Obtainable Device not registered (ra=
reported to Customer Support. The system will restart when this error occurs.
Retrying download of DM card in slot
retry a specific number of times before logging a failure message. Check the hardware and software
configuration, reseat the card in its ISA slot, and/or check the MVIP cabling. If the problem persists,
contact your Distributor or Customer Support.
Rx Channel Inactivity Detected
No keep-alive frames have been received over an active connection to a remote system. This
indicates that the connection or the remote node has failed (or been powered-off) without an
indication of the failure from the network. If the event continues, contact your Distributor or
Customer Support.
Security Rejection - Bridge Address Security cannot use Authentication Server
Both options (Bridge Address Security and off-node User Authentication) are not supported
simultaneously.
Security Rejection - Caller did not negotiate security
Bridge Security is configured. A caller attempted to send device data before (or without)
negotiating the Bridge Address security.
Security Rejection - HDLC not supported by the caller
A properly formed Bridge Security negotiation packet was received but the remote bridge
indicated that it did not support the HDLC protocol.
Security Rejection - Invalid Calling Line Id -
number
Security Rejection - Invalid Password (
System Device table and a password was provided, but the password provided did not match the
password in the System Device table.
Security Rejection - No Bridge Address given by caller
A normal Bridge Security negotiation packet was received, but did not contain a bridge address.
Check configuration. If problem persists, contact your Distributor or Customer Support.