Bridge filters, Configuring bridge filters, Bridge filters 222 – Cabletron Systems CSX1000 User Manual
Page 222: Configuring bridge filters 222, Bridging filters, Bridge filter

USER’S GUIDE
222 CyberSWITCH
B
RIDGE
F
ILTERS
C
ONFIGURING
B
RIDGE
F
ILTERS
Note:
Bridge dial out calls can be initiated through the use of a Known Connect list or through
the use of bridge filters. For a description of bridge dial out through bridge filters, refer to
the section titled
.
U
SING
CFGEDIT
1.
Select Bridge Filters from the Bridging menu.
2.
Configure any needed protocol definitions. These definitions will be used if you configure any
protocol filters. To configure a protocol definition:
a.
Select to add a protocol definition.
b.
Enter a user-defined name for the protocol definition.
c.
Enter the Ethernet type in hex.
d. Enter the LSAP in hex.
3.
Configure source MAC filters.
a.
Select to add a MAC filter.
b.
Enter the source MAC address.
c.
Select a distribution list.
3.
Configure destination MAC filters.
a.
Select to add a destination MAC filter.
b.
Enter the destination MAC address.
c.
Select a distribution list.
5.
Configure protocol filters.
a.
Select to add a protocol filter.
b.
Select a protocol definition Id.
c.
Select a distribution list.
6.
Configure packet data filters.
a.
Select to add a packet data filter.
b.
Enter the off set value.
c.
Enter the mask in hex.
d. Enter the data value in hex.
e.
Select a distribution list.
U
SING
M
ANAGE
M
ODE
COMMANDS
Manage Mode can be used to complete all of the bridge filter configuration. This section provides
you with the commands available for each bridge filter type.