Compression information commands, Dhcp commands, Frame relay commands – Cabletron Systems CSX1000 User Manual
Page 535: Dhcp c

Workgroup Remote Access Switch 535
S
YSTEM
C
OMMANDS
Compression Information Commands
C
OMPRESSION
I
NFORMATION
C
OMMANDS
Compression statistics are only available for connections that are using a compression protocol.
The following commands are used to display current compression information:
cmp stats
Displays the compression statistics for all active connections. Refer to
, for
a list of available compression statistics and their definitions.
cmp stats
Displays the compression statistics for the indicated device. Refer to
, for
a list of available statistics and their definitions. Note that the device name is case sensitive.
cmp clear
Clears the compression statistics for the indicated device. If the device name is omitted, no
compression statistics will be cleared. Note that the device name is case sensitive.
cmp clearall
Clears the compression statistics for all devices.
DHCP C
OMMANDS
These commands allow you to display or erase DHCP statistics.
DHCP stats
Displays the DHCP statistics. For a listing of available statistics and their definitions, refer to
.
DHCP stats clear
Clears the DHCP statistics.
ip addrpool
Displays the current IP address pool. Refer to the
ip addrpool
command description under
.
F
RAME
R
ELAY
C
OMMANDS
The following commands are used to display information concerning both the status and traffic
statistics of a particular frame relay connection.
fr a
Sets an internal variable. The frame relay
will be the assumed current access for
all subsequent frame relay system console commands entered.
current access, until it is changed through issuing another
fr a
command. The
access configuration.