Cabletron Systems CSX1000 - Manual (Page 458)

USER’S GUIDE
458 CyberSWITCH
[IP RIP] Unable to open RIP/UDP port 520
The UDP port for RIP was unable to be opened. There are 63 possible UDP ports, and none are
available for use at this time. No RIP information can be transmitted or received. Contact your
Distributor or Customer Support.
[IP RIP] Unable to register WAN Connection notification
The IP RIP protocol was unable to register with the IP WAN interface connection notification
system. No WAN connection information will be reflected in the RIP packets. Contact your
Distributor or Customer Support.
[IP RIP] Unable to register with Network Interface Maintenance
The IP RIP protocol was unable to register with the IP network interface notification system. Any
dynamic changes of the network interface configuration will not be reflected in the RIP interface
control. Contact your Distributor or Customer Support.
[IPX] Invalid IPXWC passed
In the unlikely event this message is posted, contact your Distributor or Customer Support.
[IPX] Network initialized successfully on xxxxxxxx:xxxxxxxxxxxx
This message is posted when the numbered interface is successfully initialized on the indicated IPX
address.
[IPX] Network Interface on LAN port not initialized
The network interface for the LAN port indicated was not initialized because there is no Ethernet
resource configured, or the Ethernet resource that is configured does not have the corresponding
port. You should correct the system configuration.
[IPX] Route not added: invalid next hop(
The static route entry indicated by the was not added in the IPX routing
table because the next hop indicated by the is not located on any network directly
connected to the configured network interface.
[IPX] Route () not added: invalid next hop ()
The static route entry indicated by the was not added in the IPX routing
table because the next hop remote device indicated by the does not exist.
[IPX] IPX router initialized successfully
This message is posted when the IPX Router feature has initialized successfully.
IPX spoofing unable to get disconnect time structure. Default options replacing disconnect time options for
device .
The resources required to properly perform the configured IPX spoofing options for the specified
device after a connection to this device has been disconnected could not be obtained. The default
IPX spoofing options are being used in place of the disconnect time IPX spoofing options.
[IPX RIP] Buffers allocated
The IPX RIP successfully allocated the buffers needed to transmit IPX RIP packets.
[IPX RIP] RIP Protocol Initialization successful
The IPX RIP protocol was successfully initialized.