Cabletron Systems CSX1000 - Manual (Page 375)

Workgroup Remote Access Switch 375
S YSTEM V ERIFICATION
Verifying SNMP is Operational
2. If Remote Mac appears in Select a file server: box, then AppleTalk Routing over the WAN
connection is operational.
3. If Remote Mac IS NOT displayed, then AppleTalk Routing feature over the WAN connection
is not operational. Refer to
AppleTalk Routing Operation Over the WAN Connection in the Problem
Diagnosis chapter.
V ERIFYING SNMP IS O PERATIONAL
1. To verify that the SNMP feature is operational, enter the snmp stats command at the
administration console. If the statistics display appears, the SNMP subsystem should be fully
operational. If the following message is displayed, SNMP is not operational:
SNMP is not enabled
If the preceding message is displayed, refer to SNMP in the Problem Diagnosis chapter for
possible actions you may take to make the SNMP feature operational.
2. To verify that the MIB objects can be retrieved via the SNMP get command, begin by making
sure that the latest version of the enterprise MIB (the ih_mib.asn file) has been compiled at the
desired SNMP network management station(s). Once the new version of the MIB is compiled,
you can issue the SNMP get command.
3. To verify the CyberSWITCH SNMP Agent is returning the correct values, it is possible to
compare the values of the MIB objects retrieved via the SNMP get command to the output
available via various system administration console and dynamic management commands.
For example, the
isdn usage console command displays B-channel information. This
information corresponds to the MIB isdnUsageMonitor group objects, a subset of the
ihSystemMonitor group. The
dr console command will return output that contains
information that corresponds to the MIB ihStatusReport table. Other console commands that
will output information that includes values that correspond to MIB objects are
ds , udp stats ,
ip stats, and snmp stats.