Cabletron Systems CSX1000 - Manual (Page 460)

USER’S GUIDE
460 CyberSWITCH
L3_CallRefSelect Call Reference wrapped
Status message indicating that Layer 3’s call reference value has wrapped. If this message is posted
frequently, report the problem.
LAN Adapter Abort
The Ethernet adapter or subsystem is being interrupted as part of the error recovery process. If the
system fails to operate normally, or the warning continues to occur, then report the event using the
problem reporting form included in Getting Assistance.
LAN Adapter Command Timeout
The system expected a command from the LAN adapter or subsystem that it did not receive. Check
for proper LAN adapter configuration and hardware installation. If it persists, report the event
using the problem reporting form included in Getting Assistance.
LAN Adapter configuration conflict
There is a configuration conflict between the Ethernet resource that was installed and the Ethernet
resource that was configured. Correct the configuration to match the installation.
LAN Adapter Fatal Error Reported
LAN Adapter hardware failure detected. If the problem persists, replace your LAN adapter.
LAN Adapter FIFO Data Underrun
The system expected data from the adapter that it did not receive, and the system will continue to
operate. Check for proper LAN adapter configuration and hardware installation.
LAN Adapter FIFO not empty, status=
The LAN adapter did not enter the proper state after it was restarted. Check for proper LAN
adapter configuration and hardware installation.
LAN Adapter HW upgrade may be required
Older versions of the Ethernet adapter may need to be updated to run Release 2.3 or greater. If the
above message appears in your system log messages, you will need to remove your Ethernet
adapter to determine if it is a version that needs to be updated. Refer to the “Notes and Warnings”
section of the Release Notes for further instructions.
LAN Adapter HW upgrade required
Older versions of the Ethernet adapter may need to be updated to run Release 2.3 or greater. If the
above message appears in your system log messages, you will need to upgrade your Ethernet
adapter.
LAN Adapter LAN Controller error
The system detected an error with the LAN controller. The LAN adapter card may be faulty.
Contact your Distributor or Customer Support.
LAN Adapter not configured
The system tried to access the bridging function when it was not configured. Most likely, the
Ethernet resource was accidentally deleted. Correct the system configuration to reflect the proper
Ethernet resource.
LAN Adapter out of receive buffers for LAN port
The LAN adapter is temporarily out of receive buffers for the indicated port. This condition should
clear itself. If the condition persists, contact your Distributor or Customer Support.