Cabletron Systems CSX1000 - Manual (Page 102)

C
ONFIGURING
B
ASIC
IP R
OUTING
O VERVIEW
This chapter provides information for configuring basic IP routing features. Basic IP routing
configuration includes:
• enabling/disabling the Internet Protocol (IP)
When you enable this option, the system operates as an IP Router. If you also enable bridging,
it will route IP packets and bridge all other packet types.
• configuring the IP operating mode
The operating mode may be either host or router. The router operating mode is the default. The
IP host mode allows you to use IP applications, such as Telnet and SNMP, without enabling IP
routing.
• configuring network interfaces
Network Interfaces define the IP networks to which the CyberSWITCH provides access. If IP
RIP is enabled, this also includes IP RIP interface information.
• configuring static routes (this includes default routes)
Other routers on the network that support IP RIP will not need static routes; IP RIP will
maintain those routes. However, static routes must be configured to identify remote networks
connected across the WAN, and for routers that do not support IP RIP.
• enabling/disabling IP RIP
IP RIP automates the maintenance of routing tables on IP devices.
A separate chapter, Configuring Advanced IP Routing , provides information for configuring
advanced IP routing features. Advanced IP routing features include:
•
configuring static ARP table entries
• enabling/disabling the isolated mode
• enabling/disabling static route lookup via RADIUS
• configuring the IP address pool
• configuring IP filters
• configuring DHCP
I NTERNET P ROTOCOL (IP) O PTION
E NABLING IP
U SING CFGEDIT
1. Internet Protocol (IP) routing is disabled as a default. To begin the IP routing configuration, you
must first enable IP routing. Select IP Routing from the Options menu.
2. Follow the onscreen instructions for enabling IP routing. Once IP has been enabled, the full IP
Configuration menu will be displayed as shown below: