Cabletron Systems CSX1000 - Manual (Page 289)

Workgroup Remote Access Switch 289
C ONFIGURING IPX
IPX Isolated Mode
IPX T YPE 20 P ACKET H ANDLING C ONFIGURATION E LEMENTS
IPX T YPE 20 P ACKET H ANDLING S TATUS
You may enable or disable IPX type 20 packet WAN forwarding. When it is enabled, you may
specify devices that can use this feature.
IPX T YPE 20 P ACKET H ANDLING D EVICE C ONFIGURATION E LEMENTS
Once you enable the feature, you can then enter devices to use the feature. The following
configuration elements are entered for each device.
IPX T YPE 20 P ACKET D EVICES
The device name of the previously configured device.
IPX T YPE 20 P ACKET F ORWARD C ONTROL M ETHOD
Allows you to determine under what conditions IPX type 20 broadcast packets will be broadcasted
to the designated device.
IPX T YPE 20 P ACKET H ANDLING B ACKGROUND I NFORMATION
In order for certain protocol implementations, such as NetBIOS, to function in the NetWare
environment, routes must allow a broadcast packet to be propagated throughout an IPX internet.
The IPX type 20 packet is used specifically for this purpose.
However, it is not practical, nor sometimes desirable, to propagate broadcast packets over the
WAN. To help you control IPX type 20 packets more flexibly, this configuration allows IPX type 20
broadcast packets to be propagated to only certain remote devices under certain conditions (for
example, only when the connection is up, or always).
IPX I SOLATED M ODE
C ONFIGURING IPX I SOLATED M ODE
U SING CFGEDIT
1. Press 9 from the IPX menu to configure the IPX isolated mode.
2. Follow the onscreen instructions to enable or disable the IPX isolated mode.
U SING M ANAGE M ODE C OMMANDS
ipxiso
Allows you to enable/disable IPX isolated mode.
IPX I SOLATED M ODE C ONFIGURATION E LEMENTS
Isolated Mode Status
You may enable or disable the isolated mode.