Cabletron Systems CSX1000 - Manual (Page 469)

Workgroup Remote Access Switch 469
S YSTEM M ESSAGES
System Message Summary
PVC for DLCI > not ACTIVE
A frame was received on the PVC associated with the indicated DLCI which was not active. This is
a temporary condition, and results from an asynchronous operation between the network and
customer-premise equipment regarding the state of the individual PVCs. If this problem persists,
contact your Distributor or Customer Support.
PVC not allocated for
The frame relay software received a frame from the network on PVC using the indicated DLCI
which has not yet been configured. It is likely that there is a configuration mismatch between nodes
in the network such that a node is transmitting data to the node logging this error via a valid but
as yet unallocated PVC.
PVC rcv wait q already full
Indicates a lack of system resources to handle the level of traffic being experienced. Contact your
Distributor or Customer Support.
RADIUS authentication is not available. You must first ENABLE RADIUS user level authentication.
An attempt was made to configure the Terminal Server Security for RADIUS and RADIUS was not
configured on the CyberSWITCH.
RBS: Channel - Backing off of channel, GLARE detected.
An incoming and outgoing call occurred on the indicated channel at roughly the same time. The
system discontinued the outgoing call in order to allow the incoming call to be established.
RBS: Encountered unknown source ID.
RBS_out_SM: NO Dial Digits supplied.
RBS: Received unknown primitive from CC.
RBS: Received unknown primitive from L1.
RBS: Received unknown primitive from ME.
RBS: Received unknown primitive from RBS.
The above Robbed Bit Signaling messages indicate that the system software sent a message to the
RBS state machine that the state machine was unable to recognize or the information was incorrect.
If this message is displayed in the log messages, contact your Distributor or Customer Support.
RBS: LIF_AddTimer failure.
An event occurred that the RBS task interpreted as a call signaling event, but layer 1 is not properly
initialized. Ensure that an ISDN line is not plugged into a RBS card.
RBS: LIF_GetBuffer failure.
RBS: Unable to send host CALL_CLEARED.
RBS: Unable to send host CALL_CONNECTED.
RBS: Unable to send host CALL_REQUEST_ACK.
RBS: Unable to send host HOST_CALL_INDICATION.
RBS: Unable to send host REMOTE_DISCONNECT
RBS: Unable to send package to host.
The above Robbed Bit Signaling messages indicate that the WAN card is not communicating
properly with the host, probably due to a card failure. Contact your Distributor or Customer
Support.
RBS_out_SM: Timeout waiting for WINK.
The system went off-hook and the switch never “winked” back, going off-hook for a specified
amount of time and then returning to on-hook. The switch must wink back in order to tell the