Cabletron Systems CSX1000 - Manual (Page 455)

Workgroup Remote Access Switch 455
S YSTEM M ESSAGES
System Message Summary
[IP] Invalid RLAN IP Address , RLAN IP Stream Closed
The connection from a HDLC Bridge or a PPP device came up and the IP (sub-) network number
configured for it is invalid; it does not belong to any of the WAN (RLAN) interfaces. Correct the IP
address for the remote device.
[IP] Invalid Peer IP Address , WAN IP Stream Closed
A PPP or RFC 1294 (IP Host) connection came up, and the IP address of the peer device (pre-
configured or negotiated) belongs to a WAN (RLAN) Interface. If the IP address is preconfigured,
try changing the peer’s IP address (at the peer device and possibly on the device entry for the peer)
that belongs to one of the WAN, WAN (Direct Host), or WAN (UnNumbered) interfaces. If the IP
address is negotiated, try changing the IP address pool, or make sure that you really do want to use
a WAN (RLAN) Interface.
[IP] IP host is initialized successfully
This message is posted when the system IP Host feature has initialized successfully.
[IP] IP router is initialized successfully
This message is posted when the system IP Router feature has initialized successfully.
[IP] Network initialized successfully on ddd.ddd.ddd.ddd
This message is posted when the numbered interface is successfully initialized on the indicated IP
address.
[IP] Network Interface on LAN port already exists
There is another network interface that is configured for the LAN port indicated, and it was already
initialized successfully. This means that there are multiple network interfaces configured for the
same LAN port. You should correct the system configuration.
[IP] Network Interface on LAN port not initialized
The network interface for the LAN port indicated was not initialized because there is no Ethernet
resource configured, or the Ethernet resource that is configured does not have the corresponding
port. You should correct the system configuration.
[IP] Route () not added, invalid next hop ()
The static route entry indicated by the was not added in the routing table because
the next hop indicated by the is not located on any network directly connected to
the configured network interface.
IPSec - Duplicate SA, Final Dest Addr: nn.nn.nn.nn SPI nn.nn.nn.nn
A Security Association with the same SPI and Final Destination Address already exists. If there is
no SPI parameter listed, the Security Association table has been filled.
IPSec Security Associations initialized successfully
[IP] WAN (Direct Host) Interface for LAN port already exists
There is another WAN (Direct Host) type interface that is configured for the LAN port indicated,
and it was already initialized successfully. This means that there are multiple WAN (Direct Host)
type interfaces configured for the same LAN port. Use CFGEDIT to specify primary or secondary
interface.