beautypg.com

Cabletron Systems CSX1000 User Manual

Page 546

background image

USER’S GUIDE

546 CyberSWITCH

pkt capture [all/idle/reqd/pend/actv/none]

Specifies which packets will be captured by the Packet Capture feature. A definition of each
possible parameter follows.

all

All packets will be captured.

none

No packets will be captured.

reqd

Only packets causing a connection to be requested will be captured.

pend

Only packets received while a requested connection is pending will be captured.

idle

Only packets not causing a connection to be requested will be captured. This could be
caused by the destination site not being in the Initiate Connection List, or by the route not
being in the IP Routing Table.

The

pkt capture

command allows multiple connection modes to be specified on a single

command line. For example, the command:

pkt capture reqd pend

captures only packets that cause a connection to be requested and packets that were received
before the connection became active.

pkt load

Loads previously saved Packet Capture file into memory.

pkt save

Saves captured packets to a disk file. Full path names are allowed, for example:

A:MYPKT.DAT.

pkt display

Displays captured packets that have been collected via

pkt on

or via

pkt load

. Note that this

command is not supported for a Telnet session.

This manual is related to the following products: