Cabletron Systems CSX1000 - Manual (Page 369)

Workgroup Remote Access Switch 369
S YSTEM V ERIFICATION
Verifying IP RIP
perform the verification steps. It also uses the show ip route command. The show ip route
command is used by a specific router to display the IP routing table. Substitute the equivalent
command for your IP router.
The steps to verify the operation of IP RIP output processing on a WAN interface are:
1. Make sure that a dedicated connection between system and Router is up and operational. On
the system’s administration console:
Type: cs
If the connection to Router is displayed, the continue with the next step.
2. Determine if Router has learned the route to 192.1.1.0 from the system. On the Router:
Type: show ip route
If the route to 192.1.1.0 is displayed, the IP RIP output processing is operational.
If the route is NOT displayed, refer to IP RIP Output Processing on a WAN Interface in the Problem
Diagnosis chapter.
V ERIFY IP RIP I NPUT P ROCESSING O PERATIONAL ON A WAN I NTERFACE
To verify that IP RIP Input Processing (routes learning) is properly operational on a WAN interface,
the IP RIP processing must be successfully initialized.
The same example that is used in the previous section is used to verify IP RIP input processing on
a WAN interface.
To verify the operation of IP RIP Input processing on a WAN interface:
1. Make sure that a dedicated connection between system and Router is up and operational. On
the CyberSWITCH administration console:
Type: cs
If the connection to Router is displayed, the continue with the next step.
2. Determine if system has learned the route to 192.1.2.0 from the Router. On the CyberSWITCH
administration console:
Type: ip route
If the route to 192.1.2.0 is displayed, the IP RIP input processing is operational.
If the route is NOT displayed, refer to IP RIP Input Processing on a WAN Interface in the Problem
Diagnosis chapter.
Dedicated Connection
Router
192.1.1.1
100.1.1.1
100.1.1.2
192.1.2.1
CSX1200
WORKGROUP REMOTE ACCESS SWITCH
LAN 10BASE-T RX TX SERVICE CH-2 D-CH CH-1 SYNC POWER LINE 1 CH-2 D-CH CH-1 SYNC
LINE 2 CH-2 D-CH CH-1 SYNC
LINE 3 CH-2 D-CH AGI
CH-1 SYNC
LINE 4