TeeJet Matrix 840G User Manual - Manual (Page 42)

www.teejet.com
68
●
98-05141 R2
69
●
Field View
To access the Field View screen.
1. Press HOME BUTTON or press the screen
to activate the icons and select HOME ICON
in bottom left corner of screen.
2. Select FIELD VIEW from Home Menu .
Figure 3-34: Home Menu - Field View
Swath acres
0.0 0
0.0
Field Boundary
Field boundaries establish application area and
determine the no apply zone.
NOTE: A Field Boundary can be created in either
Last Pass Guidance while in Vehicle View or
during any guidance while in Field View.
To create a fi eld boundary:
1. Drive to a desired location at the perimeter of the
fi eld/area.
2. While the vehicle is in motion, press
BOUNDARY ICON .
3. Travel the perimeter of the fi eld/area.
4. Finish boundary:
►Travel to within a swath width of the starting
point. The boundary will close automatically (the
white guideline will turn black).
►Press BOUNDARY FINISH ICON . A
straight line will complete the boundary between
your current location and the starting point.
NOTE: If a swath was applied while creating a
boundary, the boundary line will be to the
exterior of the applied swath.
NOTE: The BOUNDARY FINISH ICON is not
available for selection (grayed out) until the
minimum distance is traveled (five-times the
swath width).
Use CANCEL BOUNDARY ICON to cancel
the new fi eld boundary process and revert to the
previous boundary (when established).
Figure 3-35: Boundary in Progress
mph acres
2.75 12.3
Figure 3-36: Boundary Established
mph acres
4.92 12.4
Figure 3-33: Overview of Field View
On Screen Guidance
• Guidelines
►Orange – active guidance line
►Black – boundary line
• Points - markers for established points
►Red Point – Return to Point
►Blue Point – Mark A
►Green Point – Mark B
• Coverage Area – illustrates applied area and
overlap:
►Blue – one application
►Red – two or more applications
• Zoom In/Out – adjust the map’s visible area.
Button Assistance
• Zoom In/Out & Perspective – adjust the map’s
visible area.
FIELD VIEW
Field View creates a computer-generated image of the vehicle position and application area from
an aerial perspective. From this screen one can access options for boundary areas and a marked
point or enter World View and Pan modes.
mph acres
0.53 14.6
5.8
Guidance Bar
Field View
(Zoom In/Out)
or can use Zoom In/Out
Buttons
Vehicle Representation
Pan Mode
World View
Status Bar Navigation Guidelines
Mark Boundary
Finish Boundary
Mark Point
Return to Point
Cancel Boundary
Cancel Point
Home/Menu Options
or press Home Button
Painted Coverage Area