TeeJet Matrix 840G User Manual - Manual (Page 25)

www.teejet.com
36
●
98-05141 R2
37
●
NOTE: BoomPilot settings are only visible and
necessary if a SmartCable or SDM is
present. If neither is present, see Single
Boom Setup section.
Figure 2-38: Boom Section Setup (SDM detected)
Overlap
Overlap determines the amount of overlap allowed
when the boom sections are turned on and off using
BoomPilot.
1. Press OVERLAP ICON .
2. Press UP/DOWN ARROW ICONS to
change between:
►0%
►50%
►100%
3. Press
►PAGE RIGHT ARROW to proceed to Delay
On.
►BOOMPILOT/SINGLE BOOM SETUP TAB
to return to main Boom Section Setup screen.
Figure 2-39: Overlap
Figure 2-40: Examples of Overlap
100%
50%
0%
Figure 2-36: Video w/Four Channel VSM
Figure 2-37: Camera Configuration
BOOMPILOT/SINGLE
BOOM SETUP
BoomPilot Setup is used to confi gure
Overlap, Delay On, Delay Off, Number of Boom
Sections, and Boom Section Width settings.
Single Boom Setup is available when a SmartCable
or Section Driver Module (SDM) is not present.
Confi gurations for Overlap, Delay On, Delay Off,
Number of Boom Sections will not be available, and
only one boom section width can be entered.
BoomPilot Setup
If a SmartCable or Section Driver Module (SDM)
is present, up to 15 boom section widths can be
entered.
1. Select UNIT SETUP from Home Menu .
2. Press BOOMPILOT/SINGLE BOOM SETUP
TAB
3. Select from:
►Overlap – determines the amount of
overlap allowed
►Delay On – establishes the timing for the
boom section valves to switch on
►Delay Off – establishes the timing for the
boom section valves to switch off
►Number of Boom Sections
# – establishes
the number of available boom sections
►Boom Section Width – establishes the
width of each boom section
OR
Press PAGE RIGHT ARROW to cycle through
all settings.
NOTE: Options labels are current settings. While in
a setting screen, press icon to view available
factory settings and setting ranges.