Chapter 2 – unit setup, General information – TeeJet Matrix 840G User Manual User Manual
Page 16

98-05141 R2
19
●
To access the Unit Setup screens:
1. Press HOME BUTTON or press the screen
to activate the icons and select HOME ICON
in bottom left corner of screen.
2. Select UNIT SETUP from Home Menu
.
3. Select from:
►
System Setup – used to confi gure:
◄ Lightbar – used to confi gure LED
Spacing , Display/Swath Mode and
LED Brightness settings.
◄ Culture – used to confi gure Units ,
Language and Time Zone .
◄ GPS – used to confi gure GPS
Type and the GPS Port , as well
as view GPS Status information .
◄ Console – used to confi gure
Volume , LCD Brightness , Screen
Calibrate and Screenshot settings,
as well as view About information and
Save system software information .
◄ Video – used to set up individual
cameras
A
B
C
D
E
F
G
H
.
►
BoomPilot/Single Boom Setup – used
to confi gure Overlap , Delay On ,
Delay Off , Number of Boom Sections
#
and Boom Section Width settings.
►
Vehicle Setup – used to confi gure
Vehicle Type , Antenna Height ,
Direction to Boom and Boom Offset
Distance settings.
►
Tilt Gyro Module Setup – used to
calibrate the Tilt Gyro Module, allowing for tilt
correction for application on hilly or sloped
terrain.
►
FieldPilot Setup – used to confi gure:
◄ Enable/Disable FieldPilot .
◄ Valve Setup – used to confi gure
Valve Frequency, Minimum Duty Cycle
Left, Minimum Duty Cycle Right and
Maximum Duty Cycle settings.
◄ Valve Test – verifi es steering is
directed correctly and is used to fi ne
tune the oil fl ow.
◄ Confi gure FieldPilot – used to
confi gure Coarse Steering Adjustment,
Fine Steering Adjustment, Deadband,
and Lookahead settings.
General Information
Press the icon of any menu item to display a
defi nition of that item. To remove the information
box, press anywhere on the screen.
Figure 2-1: Example of Information Text Box
CHAPTER 2 – UNIT SETUP
Unit Setup is used to confi gure System Setup, BoomPilot/Single Boom Setup, Vehicle Setup, Tilt
Gyro Module Setup, and FieldPilot Setup.
NOTE: All settings are automatically saved when selected.