TeeJet Matrix 840G User Manual - Manual (Page 32)

www.teejet.com
50
●
98-05141 R2
51
●
Figure 2-68: Valve Test
Confi gure FieldPilot
Confi gure is used to confi gure Coarse Adjustment,
Fine Adjustment, Deadband and Lookahead
settings.
1. Press CONFIGURE ICON .
2. Select from:
►Coarse Steering Adjustment – adjusts how
rapidly the vehicle approaches a guideline in
Straight A-B
►Fine Steering Adjustment – adjusts how
rapidly the vehicle approaches a guideline in
Curved A-B
►Deadband – adjusts if steering is too
choppy/responsive or remains consistently off
the guideline
►Lookahead – used during Straight A-B
Guidance mode to adjust the vehicle’s approach
to the guideline
OR
Press PAGE RIGHT ARROW to cycle through
all settings.
NOTE: Options labels are current settings. While in
a setting screen, press icon to view available
factory settings and setting ranges.
Figure 2-69: Configure Screen
Figure 2-67: Maximum Duty Cycle
Valve Test
The Valve Test verifi es steering is directed correctly
and is typically used to fi ne tune the oil fl ow to
properly calibrate the amount of time to steer the
wheels from full left to full right (lock to lock) for non-
proportional valves.
NOTE: For non-proportional valves, the amount of
time for left to right / right to left (lock to lock)
will be established by mechanically adjusting
oil flow through the valve. Refer to your
vehicle user manual for specific instructions.
1. Press VALVE TEST ICON .
2. Turn the wheels all the way to the left.
3. Press the GREEN ARROW . This will start a
timer below the STOPLIGHT as well as turn the
vehicle to the right.
4. Press the RED STOPLIGHT when the
wheels are all the way to the right. The time
displayed under the STOPLIGHT is the lock to
lock time.
5. Turn the wheels all the way to the right.
6. Press the RED ARROW . This will start a
timer below the STOPLIGHT as well as turn the
vehicle to the left.
7. Press the RED STOPLIGHT when the
wheels are all the way to the left. The time
displayed under the STOPLIGHT is the lock to
lock time.
8. Press FIELDPILOT SETUP TAB to return to
main FieldPilot Setup.