Juniper Systems Archer 2 User Guide - Manual (Page 91)

Ch 9 Barcode Scanner 87
The General screen has the following functions:
„
Scan Time – Adjust the scan time, which is the duration of
time before the scanner times out.
„
Enable or disable Aiming Crosshairs.
„
Enable or disable Decoding Illumination (red light).
„
Illumination Brightness – For better barcode performance,
we recommended that you leave illumination brightness
at the maximum value of 10.
„
Pick List Mode – Enable this mode if barcodes are close
together. The scanner only decodes barcodes aligned
directly under the center of the aiming crosshairs. Disable
this mode if only one barcode is viewable. The aiming
crosshairs do not have to line up directly on the barcode
in order for the scanner to read it. Just aim the scanner
in the general area where the barcode is located. This
can be helpful in situations where it might be difficult to
precisely aim the scanner, such as in locations with bright
sunlight.
„
Consecutive Read Level – Select how many successful
consecutive reads the barcode must get before being
decoded.
Data Format Screen