Juniper Systems Archer 2 User Guide - Manual (Page 8)

4 Archer 2 Rugged Handheld Owner’s Manual
documents as desired. (Adobe Reader must be installed
on your computer. It is free from Adobe’s website at: www.
adobe.com.)
Apply a Screen Protector (Optional)
The touchscreen is extremely scratch resistant, so a screen
protector is not included with the Archer 2. If you decide to
apply one, refer to the installation instructions included with
your screen protector for specific details.
Install the Battery Pack, SD Card, and SIM Card
The Archer 2 uses a rechargeable Li-Ion battery pack. Install
and charge the battery pack as follows:
1. The battery compartment is accessed from the back of
the handheld. Loosen the 4 captive screws holding the
battery compartment door in place using a #1 Phillips
screwdriver. Remove the door. You do not need to
remove the hand strap.
CAUTION: The Archer 2 is not sealed against water and
dust when the battery door is not installed.
2. If you are using a micro SD card for additional memory
or a SIM card with the 3G Data Modem (optional), you
can install them now before you install the battery pack
or at another time. See more details about these cards
in Chapter 2, Hardware Components, Micro SD Cards
and Chapter 8, 3G Data Modem, Install the SIM Card.
3. Place the Li-Ion battery pack in the compartment.
!