Juniper Systems Archer 2 User Guide - Manual (Page 42)

38 Archer 2 Rugged Handheld Owner’s Manual
Suspend, Reset, Power Off, and Restore Defaults
Use the power button to suspend, reset, power off, or
restore the Archer 2 to its factory state. To access the Power
Button menu, press and hold the power button.
Suspending and Resuming the Archer 2
We recommend suspending your handheld if you plan to
turn it off for less than two weeks. While it is suspended, you
should attach it to a wall charger when it is not in use.
Suspending the handheld is different from powering it off.
When the device is suspended it goes into a very low power
mode. Some battery power is used during suspend.
1. Press and release the power button . The backlight
shuts off. It can take several seconds to fully suspend,
especially when the cell modem is on.
2. To resume the device from suspend mode, press and
release the power button again. When it is resumed,
the handheld resumes where it was before it was
suspended.
3. There is also a Suspend option on the Power Button
menu.