Juniper Systems Archer 2 User Guide User Manual
Page 25
Ch 2 Hardware Components
21
Alternately, go to the Backlight control panel. Press Start >
Settings > System > Backlight. Near the bottom of the screen
it says “Adjust Power Settings to conserve power.” Select the
hyperlink power (see the previous screen shot).
The Power control panel appears. Select Advanced from
the horizontal scrolling menu near the top of the screen.
For battery and external power select how long the screen
stays on when it is not in use. Shorter times save battery
power.
Disabling and Enabling the Touchscreen
You can disable the touchscreen. This is useful when you
are running an application and you want to see the screen
while avoiding accidental touchscreen activation. The
touchscreen can also be disabled for cleaning purposes.
Press the shift + backspace buttons to toggle the
touchscreen on and off.
Press and hold the power button to display the Power
Button menu. Select Disable TS. (You must use the method
described above to enable the touchscreen.)
When the touchscreen is disabled, this icon
is shown in
the title bar until the touchscreen is enabled again. You can
move around and make selections using the keypad.