beautypg.com

Sd cards, Connector i/o module – Juniper Systems Archer 2 User Guide User Manual

Page 30

background image

26

Archer 2 Rugged Handheld Owner’s Manual

SD Cards

The Archer 2 has a slot for a micro SD card located in the

battery compartment. To insert or remove a card follow

these steps:
1. Power off the handheld.
2. Loosen the screws to the battery compartment, and

remove the door. The hand strap remains attached.

CAUTION: The Archer 2 is not sealed against water and

dust when the battery door is not installed properly.

3. Remove the battery pack.
4. An image on the battery compartment label shows the

correct location and orientation for the SD card (slot

on the right). Push the card into the slot to insert it. To

remove the SD card, pull it out.

5. Replace the battery pack, and attach the battery door.
6. Power up the handheld.

Connector I/O Module

The Archer 2 connector I/O module has the following jacks

and connectors:

1. USB client, micro B
2. Audio jack: 3.5mm; supports speaker, microphone or

stereo output (pin detect)

!

2

3

4

5

1