Juniper Systems Archer 2 User Guide - Manual (Page 115)

Ap C Warnings and Regulatory Information 111
Radio Frequency Safety
This device has been evaluated for use in close proximity
to the body. Use only accessories approved by Juniper
Systems. The use of third party accessories may not comply
with FCC and international RF exposure requirements.
To comply with FCC and other national RF exposure
requirements do not co-locate this device with other
transmitters.
This device operates in compliance with the FCC radio
frequency exposure limits for an uncontrolled environment.
Users must follow instructions provided in the user
documentation to satisfy compliance with FCC radio
frequency exposure requirements.
There cannot be any alteration to the authorized antenna
system.
CE Marking (European Union)
Products bearing the CE marking comply with the
2004/108/EC (EMC Directive), 1999/5/EC (R&TTE
Directive), 2006/95/EC (Low Voltage Directive) issued by the
Commission of the European Community.
CE compliance of this device is valid only if powered
with/by a CE-marked wall charger provided by the
manufacturer. Cables connecting to the USB host port
must use a ferrite core/bead on the cable. The ferrite core
must be placed on the cable near the end that connects
to the Archer 2. This device has been evaluated using
the following standards to demonstrate compliance with
applicable directives:
„
EN 60950-1:2006
„
IEC 62209-2 Ed. 1.0
„
IEEE Std. C95.1-1999
„
EN 301 489-1 V1.8.1
„
EN 301 489-7 V1.3.1
„
EN 301 489-17 V2.1.1
„
EN 300 328 V1.7.1
„
EN 301 511 V9.0.2