Juniper Systems Archer 2 User Guide - Manual (Page 65)

Ch 6 GPS/GNSS 61
100, and default file type is .kml, file names would be
Point110.kml, Point120.kml, Point130.kml, etc.) Also select
the number of points to average. The default is 1.
„
Track Settings: Set up the track file naming scheme (see
Waypoint Settings). You can select a minimum time and
minimum distance needed before a point is collected. If
both are enabled, both conditions must be met before a
point is added to a track. You can disable suspend when
track points are being collected.
„
Audio Notifications: You can turn on notifications for
waypoint arrival, waypoint collected, and track point
collected.
Some settings can be customized for a particular waypoint
or track using edit on the data collection screens.
View Signal Strength and NMEA Strings
View the strength of satellites being used in a fix (shown in
green) by swiping the area where position is shown on the
Home screen to the right. View the NMEA strings that are
coming in through the GNSS receiver by swiping the same
area to the left. Strings can be saved to a file.
Collect Waypoint Data
From the main JSNav screen tap the waypoint icon to
open the Collect Waypoint screen.