Juniper Systems Archer 2 User Guide - Manual (Page 80)

76 Archer 2 Rugged Handheld Owner’s Manual
3G Data Modem
The 3G data modem is an option for Archer 2 Geo models,
adding Wide Area Network data modem capability. The
modem is installed at the factory.
The modem is a cellular data modem, type GSM/UMTS. It
is five band modem compatible. The modem operates in
different modes, depending on the wireless provider and
the signal strength. Data speeds will vary anywhere from
10 or 20 Kbps when using GPRS to over 1 Mbps when using
HSDPA.
Set up a Data Account with a Wireless Provider
Contact a wireless provider to set up data service for the
cellular data modem and obtain an account and SIM card
(purchased separately). You need to provide the following
information when setting up an account:
1. Billing Information and business ID, such as your Federal
Tax I.D. or VAT number.
2. The wireless services required. Specify that you need
data service only. You do not need voice or messaging
services.
3. You may be asked for the modem’s IMEI number, which
can be found here: Start > Settings > System > System
Information > 3G Modem with the modem powered on.
4. You may be asked to provide the modem’s model
number. This number allows the carrier to verify this
modem as one of its approved models. If asked for this
by the carrier, it is a Juniper Systems Archer 2.
Install the SIM Card
To insert or remove a card follow these steps:
1. Power off the handheld.
2. The SIM card slot is located in the battery compartment.
Loosen the screws to the door and remove it.
CAUTION: Do not use a micro SIM adapter. The adapter
can get stuck and damage the slot.
!