EVCO EVF818P9 - Manual (Page 42)

EVCO S.p.A. EVF818 | Installer manual ver. 1.0 | Code 144F818E104
page 42 of 76
r2 1 500 min 240 duration of time-controlled deep freezing
r3 -99 99 °C/°F (1) 3
temperature-controlled blast chilling end time temperature;
also end temperature of the temperature-controlled soft
deep freezing phase (temperature detected by the needle
probe); see also parameter r5
r4 -99 99 °C/°F (1) -18
temperature-controlled deep freezing end temperature
(temperature detected by the needle probe); see also
parameter r6
r5 1 500 min 90
maximum duration of temperature-controlled blast chilling;
see parameter r3 also
r6 1 500 min 240
maximum duration of temperature-controlled deep
freezing; see parameter r4 also
r7 -99 99 °C/°F (1) 0
work set-point during blast chilling; also work set-point
during the soft deep freezing phase (cabinet temperature);
see also parameter r0
r8 -99 99 °C/°F (1) -40
work set-point during deep freezing (cabinet temperature);
see also parameter r0
r9 -99 99 °C/°F (1) -20
work set-point during hard blast chilling phase (cabinet
temperature); see also parameter r0
r10 -99 99 °C/°F (1) 2
work set-point during post blast chilling storage (cabinet
temperature); see also parameter r0
r11 -99 99 °C/°F (1) -20
work set-point during post deep freezing storage (cabinet
temperature); see also parameter r0
r12 -99 99 °C/°F (1) 5
work set-point during pre-cooling (cabinet temperature);
see also parameter r0
r13 -99 99 °C/°F (1) 15
end temperature of the temperature-controlled hard blast
chilling phase (temperature detected by the needle probe)
r14 10 100 % 60
duration of the time-controlled hard blast chilling phase
(intended as a percentage of the value established with
parameter r1); also duration of the time-controlled soft
deep freezing phase (intended as a percentage of the value
established with parameter r2)