EVCO EVF818P9 - Manual (Page 34)

EVCO S.p.A. EVF818 | Installer manual ver. 1.0 | Code 144F818E104
page 34 of 76
7 “PROGRAMS” FUNCTION
7.1 Foreword
The programs function can be used to memorise some settings in a program and start an operating cycle with the
settings it has memorised.
Up to 9 programs can be memorised.
7.2 Memorisation of a program
Operate as follows:
1. Make sure that the keyboard is not locked and that no procedure is in progress.
2. Hold the PROGRAMS key down for 2 seconds before starting and operating cycle or during reservation: the 1
digit display will show the number of the first program available (if the display shows “F”, it means that all
programs are already used; in this case, an existing program must be overwritten).
2.1 If the PROGRAMS key is pressed and released before starting an operation cycle, the device will memorise the
following settings:
- type of operating cycle selected
- blast chilling/deep freezing intensity selected
- if the key is pressed before starting-up a temperature-controlled cycle:
- the work set-point during blast chilling if parameter r19 is set at 0, the blast chilling end
temperature
if parameter r19 is set at 1.
- if the key is pressed before starting-up a time-controlled cycle:
- the work set-point during blast chilling if parameter r19 is set at 0, the blast chilling duration
if parameter r19 is set at 1.
2.2 If the PROGRAMS key is pressed and released during storage, the device memorises the following settings:
- type of operating cycle in progress
- the duration of blast chilling or deep freezing, i.e. the time taken to successfully complete blast chilling
or deep freezing.
- blast chilling/deep freezing intensity selected before starting an operating cycle.
- the work set-point selected before starting up an operating cycle.
The execution of a program memorised by pressing and releasing the PROGRAMS key during storage causes
the start of a time-controlled cycle.
3. Press and release the UP or DOWN key to select the program number.
4. Press and release the PROGRAMS key: the 1 digit display will switch off.
Operate as follows to abandon the procedure indicated:
5. Do not operate for 60 s (press and release the PROGRAMS key if all programs are already used).
7.3 Execution of a program
Operate as follows:
1. Make sure the device is in the "on" status.
2. Make sure that the keyboard is not locked and that no procedure is in progress.
3. Press and release the PROGRAMS key: the 1 digit display will show the number of the first program available
and the dedicated LEDs will flash (if the display remains off, it means that there is no program available).
4. Press and release the UP or DOWN key to select the program number.