EVCO EVF818P9 User Manual
Page 41
EVCO S.p.A.
EVF818 | Installer manual ver. 1.0 | Code 144F818E104
page 41 of 76
CA3
-25
25
°C/°F (1)
0
evaporator probe offset
CA4
-25
25
°C/°F (1)
0
condenser probe offset
CA5
-25
25
°C/°F (1)
0
needle probe offset 2
CA6
-25
25
°C/°F (1)
0
needle probe offset 3
P0
0
1
- - - -
0
probe type
0 = PTC
1 = NTC
P2
0
1
- - - -
0
temperature unit of measurement (2)
0 = °C
1 = °F
P3
0
3
- - - -
1
number of needle probe sensors
0 = needle probe not available
1 = 1 (needle probe 1)
2 = 2 (needle probe 1 and needle probe 2)
3 = 3 (needle probe 1, needle probe 2 and needle probe
3)
P4
0
1
- - - -
1
enabling the evaporator probe
1 = yes
P5
0
1
- - - -
1
enabling the condenser probe
1 = yes
P8
0
250
ds
5
delay displaying temperature variation detected by the
probes
P9
0
2
- - - -
2
type of backlight
0 = off during “on” status and during the “run” status
and with ON/STAND-BY key low light intensity during
the “stand-by” status
1 = with low light intensity during the “on” status and
during the "run" status and with ON/STAND-BY key
low light intensity during the “stand-by” status
2 = with high light intensity during the “on” status and
during the "run" status and with ON/STAND-BY key
high light intensity during the “stand-by” status
Par.
Min.
Max.
Unit
Default
Main regulator
r0
1
15
°C/°F (1)
2
parameters differential r7, r8, r9, r10, r11 and r12
r1
1
500
min
90
duration of time-controlled blast chilling