3 user interface installation, 4 control module installation, 5 installation warnings – EVCO EVF818P9 User Manual
Page 14

EVCO S.p.A.
EVF818 | Installer manual ver. 1.0 | Code 144F818E104
page 14 of 76
3.3
User interface installation
Back panel via studs
3.4
Control module installation
On flat surface, with spacers.
3.5
Installation warnings
-
make sure that the device work conditions (temperature of use, humidity, etc.) lie within the limits indicated;
see chapter 15 "TECHNICAL DATA"
-
do not install the device near to any heat sources (heating elements, hot air ducts etc.), equipment containing
powerful magnets (large diffusers, etc.), areas affected by direct sunlight, rain, humidity, excessive dust,
mechanical vibrations or shocks.
-
any metal parts in proximity of the control module must be at a distance such that they do not compromise the
safety distances.
-
in compliance with Safety Standards, the device must be installed correctly and in a way to protect against any
contact with electric parts; all parts that ensure protection must be fixed in a way that they cannot be removed
without the use of tools.