EVCO EPD4DF3 Installer manual - Manual (Page 29)

EVCO S.p.A. EVDRIVE03 | User manual ver. 3.4 | Code 144EPDE344
page 29 of 70
page 23
page 33
or and or and or and
page 34 page 35 page 36
- - - - - - -
page 23
or
page 23 page 23
and or to set and or to set
level 5 password level 5 password
page 37 page 38
The backup and restore functionalities are active only in Stand-by off (10). They are protected by the Level 5
password and permit to download a copy of the EVDRIVE03 application's parameters and/or the driver's
parameters (calibrations of analogic inputs, communication settings, etc.) in the memory or in the parameters
key.
The user can restore the parameters with the copy in the memory or in the parameters key.
To modify a parameter operate as follows:
29.
Press and release button UP or button DOWN to select possible submenus.
30. Press and release button ENTER.
31. Press and release button UP or button DOWN to select the parameter.
32. Press and release button ENTER.
33. Press and release button UP or button DOWN to modify the value.
34. Press and release button ENTER to confirm the value.
35. Press and release button ESC over and over again to go back to the previous pages.
7.3 Configuring a blind version
The following procedures show an example of configuration of a blind version through an user interface (in the
example Vgraph) and through its user interface.