EVCO EPD4DF3 Installer manual - Manual (Page 26)

EVCO S.p.A. EVDRIVE03 | User manual ver. 3.4 | Code 144EPDE344
page 26 of 70
or and
page 8 page 9/11
or
page 10/12
The first five pages are dedicated to the end user and permit display of major features of the EVDRIVE03, any
alarm messages, or whether it is necessary to resynchronise or reset the machine after changing parameters.
In the third page, the fourth line is visible and blinking only if there is a request for resynchronization; the last
line signalizes a request to disable (blinking "disable request”) or a request to reset the board (negative
blinking “reset request”).
In the “User configuration” pages, some manual and debug mode functions are also available, including the
direct setting of SH set-point to pass to the algorithm.
To modify a parameter operate as follows:
3.
Make sure to have selected an “User configuration” page.
4. Press and release button UP or button DOWN to select a submenu.
5. Press and release button ENTER.
6. Press and release button UP or button DOWN to select the parameter.
7. Press and release button ENTER.
8. Press and release button UP or button DOWN to modify the value.
9. Press and release button ENTER to confirm the value.
10. Press and release button ESC over and over again to go back to the previous pages.
To gain access to the installer menu:
11.
With reference to step 2, from page 1 press button LEFT (or from page 7 press button RIGHT).
12. Press and release button ENTER.
13. Press and release button UP or button DOWN over and over again to set level 1 password (according to the
factory settings “10”; to change this value look at paragraph 7.6 “Main menu”.
14. Press and release button ENTER again.
15. Move among the pages using the buttons as shown in the example here below:
to page 1 page 13 to page 1
or and or and
page 14 page 16
or or