Comtrol RocketPort Serial Hub Series - Manual (Page 54)

54 RAS Installation and Configuration
Windows NT
5. The Add RAS Device window displays:
6. Use the droplist to select the COM port (modem) that you want to
configure and click the OK button.
The Remote Access Setup window displays again:
7. Highlight the desired COM port (Modem) and click the Configure
button.
8. The Configure Port Usage window displays:
9. Select the appropriate radio button, based on the role the modem
will perform, and click the OK button.
Note: When configuring multiple simultaneous RAS dial-in ports,
configure the ports to “Receive calls only” not “Dial out and
Receive.” Configuring a port to dial-out requires a separate
memory pool for each dial-out port, while all ports
configured for receive-only share the same memory pool.
If you configure too many ports for dial-out unnecessarily,
resources can become an issue. If you require dial-out on the
RAS server, configure one port to “Dial out and Receive”
and all the other ports to “Receive calls only.”
The Remote Access Setup window displays again.
10. Highlight the COM port (modem) again and click the Network
button.