Click ok to save the configuration, Shut down the system and restart the computer, Reboot the system so that the new unit initializes – Comtrol RocketPort Serial Hub Series User Manual
Page 35: Adding units after the initial installation
Using VS-Link
35
Windows NT
4.
Click OK to save the configuration.
5.
Click OK to close the message about restarting your system.
6.
Shut down the system and restart the computer.
If in the event your primary server goes down, this unit will attach
itself to the server you assigned.
Adding Units After the Initial Installation
Use the following procedure to add more RocketPort Serial Hub units
to an existing installation:
1.
Connect the new RocketPort Serial Hub unit to the network and
power it up.
2.
Start up VS-Link (see Step 1 of the Accessing VS-Link Menus on
Page 31, if you need help).
3.
Click the Add button. The Add Device Wizard appears.
4.
For help with the remainder of the setup, use Installing a New
Version of VS-Link on Page 20 and start with Step 7.
5.
Reboot the system so that the new unit initializes.