Comtrol RocketPort Serial Hub Series - Manual (Page 45)

Configuring Modems 45
Windows NT
Configuring Modems
After installing the hardware and VS-Link for Windows NT, use this
discussion to configure modem COM ports.
The RocketPort Serial Hub can support any asynchronous serial
modem for use by any application that uses TAPI. For information
regarding port pinouts and signals, see the Hardware Installation
Card.
Working with NT RAS
Comtrol products are frequently used to provide Dial-Up Networking
access with NT RAS (Remote Access Service).
• If RAS is not installed, note that you must install at least one RAS-
capable device (i.e., modem) before installing and configuring RAS.
• If RAS is installed, note that the modem installation process
automatically launches RAS Setup after modem installation is
complete.
Modem Installation
The following instructions were developed using Comtrol modem
products. If you are using another brand of modem, note that some
prompts and screen descriptions may differ from those shown.
Follow these steps:
1. If using an external modem, connect the modem to the desired port.
Power up the modem.
2. Open the Control Panel window.
3. Double-click the Modems icon.
If you have no other modems installed, skip to Step 5.