Ras installation and configuration, Initial ras installation – Comtrol RocketPort Serial Hub Series User Manual
Page 50
50
RAS Installation and Configuration
Windows NT
RAS Installation and Configuration
After installing the software, and installing and configuring at least
one RAS device (for example, a modem), use this section to install and
configure Remote Access Service (RAS).
Initial RAS Installation
If you have not previously installed RAS in your Windows NT server,
log into the server with Administrative rights and follow these steps:
Note: This example shows how to install and configure RAS for use
with modems, but you can use it as a guide to setting up other
serial devices.
1.
Open the Control Panel and start the Network applet, or right-click
on the Network Neighborhood and select Properties. The following
screen displays: