Click the options tab (under the main setup tab), Optionally, click the checkbox to enable rs-485, Click the ok button – Comtrol RocketPort Serial Hub Series User Manual
Page 38: Click the ok button on the main setup screen
38
Using VS-Link
Windows NT
2.
Click the Options tab (under the Main Setup tab).
3.
Optionally, click the checkbox to enable Verbose mode for the
Windows NT Event Log.
4.
Optionally, select a different value for the scan rate.
Note: Typically you should leave the scan rate set to the default
value (10 ms) for most applications. To adjust latency for
timing-critical applications, select a longer or shorter
interval from the droplist, or type the rate of choice in this
field. Changes to Scan Rate do not take effect until you
restart the NT server.
5.
Optionally, click the checkbox to enable RS-485.
Note: You may need to complete setting up some RS-485 features.
Go to the Configuring Specific Port Features on Page 40 for
additional RS-485 configuration.
6.
Click the OK button.
7.
Click the OK button on the Main Setup screen.