Comtrol RocketPort Serial Hub Series - Manual (Page 53)

RAS Installation and Configuration 53
Windows NT
Adding or Reconfiguring a RAS Device
There are several different ways to start this procedure:
• If you have previously installed RAS and configured at least one
RAS device, and are now adding or reconfiguring RAS devices,
begin with Step 1.
• If you have previously installed RAS and were in the process of
installing a modem when this process started automatically, begin
with Step 4.
• If you were in the process of installing RAS when this process
started automatically, begin with Step 5.
Follow these steps:
1. Open the Control Panel and start the Network applet, or right-click
on the Network Neighborhood and select Properties. The Network
window displays.
2. If Windows NT 4.0, select the Services tab.
If Windows NT 3.51, highlight the Remote Access Service selection
and click OK.
3. Highlight Remote Access Service and click the Properties button.
4. The Remote Access Setup window displays:
To reconfigure an existing RAS port, highlight the port/device and
click the Configure button. Then go to Step 8.
To add a new RAS device—for example, if you are configuring a
new modem—click the Add button.