Comtrol RocketPort USB Serial or Modem Hub Driver Installation with Windows 2000 - Manual

How to Use this Document 1
RocketPort ® USB ® Serial Hub Driver
Installation with Windows 2000
How to Use this Document
You can use the interactive Table of Contents to locate the information you need.
Note: All blue underlined text are jumps to the information referenced.
Overview
This document discusses how to:
• Install a single RocketPort USB Serial Hub.
Note: For specific hardware information, such as building cables or specifications, see the Hardware
Installation documentation, which is available on Comtrol media (diskette or CD) or you can
download the current version from the ftp/web site.
• Install multiple RocketPort USB Serial Hubs.
• Remove an existing driver.
• Install modems on the RocketPort USB Serial Hub.
• Contact Technical Support.
Comtrol hardware and software manuals are available in electronic form on Comtrol media and the Web/ftp
site. You can download driver updates at no charge from the Comtrol Web/ftp site. Always check the
Web or
ftp sites to make sure that you have the current driver and documentation. The Web site also contains
information on extracting Comtrol software .
Installation Prerequisites
You will need the following to install the RocketPort USB Serial Hub:
• A computer with the Windows 2000 operating system and a functioning USB port or hub.
Note: For information about USB support, see http://www.usb.org.
• If you are using a USB hub instead of a USB port on your PC, make sure that the hub is self-powered
(external power supply attached).
• The Windows 2000 operating system CD.
• RocketPort USB Serial Hub with the USB cable.
• Driver for the RocketPort USB Serial Hub (from CD, diskette, or downloaded file).
Note: See the Removing the Software discussion before re-installing a driver.