KEYENCE AutoID - Manual (Page 90)

4-40
SETT
ING DEVICE OPER
A
T
IONS
4
4-8 RS-485 Master Unit (N-410) Settings
Parameters to be Set
There are five parameter items to be set up for the RS-485 master unit (N-410). Switch to the
desired setting item by clicking the respective tab and set the parameters on that tab.
Registered devices are displayed when N-410 is selected at the selection area. To set parame-
ters, click the "Param" button to switch to the parameter setting display.
(1) Main setting (3) Protocol setting (4) RS-232 setting (5) RS-485 setting (2) Slave setting
Setting Item Description See Page
(1) Main setting This tab is for setting the operation mode and trigger. 4-41
(2) Slave setting This tab is for setting the slave station to be connected. 4-42
(3) Protocol setting This setting is for setting the protocol and PLC. 4-43
(4) RS-232 setting This tab is for setting communication over an RS-232 connection. 4-45
(5) RS-485 setting This tab is for setting communication over an RS-485 connection. 4-46