Cub Cadet Z-Wing - Manual (Page 74)

Cub Cadet Commercial Z-Wing
70
28.19.Jumper wires connect... : See Figure 28.19.
• Terminal #5 to terminal #4 (yellow jumper)
• Terminal #8 to terminal #1 (red jumper)
• Effectively reversing polarity in the two wires that
lead to the wing lift actuator when the rocker
switch is in the DOWN position.
28.20.Wing lift actuator: The wing lift actuator
responds to the wing lift control switch, con-
nected to it by the red (R) and yellow (Y) wires.
See Figure 28.20.
• Positive current on the red wire, with ground on
the yellow wire causes the actuator to extend,
lowering the wings.
• Positive current on the yellow wire, with ground
on the red wire causes the actuator to retract,
raising the wings.
28.21.Fuse: The fuse holder can be found on the main
harness conduit, near the left front corner of the
engine. It should contain a 20A automotive type
fuse. See Figure 28.21.
28.22.There is a second fuse holder and fuse in the
harness, to the rear of the starter motor. This
fuse is used for other applications of the engine,
and is not of any importance in this electrical
system. See Figure 28.22.
Figure 28.19
Red jumper
Yellow jumper
Figure 28.20
Red wire:
+ to extend
- to retract
Yellow wire:
- to extend
+ to retract
Figure 28.21
Fuse holder
Figure 28.22
Fuse holder:
Not used