Cub Cadet Z-Wing - Manual (Page 30)

Cub Cadet Commercial Z-Wing
26
12.16.If the nuts are loosened from their carriage bolts
in small increments and slight downward force is
applied to the bracket, the square bosses on the
carriage bolts will remain engaged to the frame.
Tape placed over the heads of the carriage bolts
will also help keep them in place.
See Figure 12.16.
12.17.Cut any cable ties that secure the lift cables to
the mower.
12.18.Lower the cable bracket assembly slightly to
clear the bolts, draw it rearward to clear the actu-
ator, and remove it. See Figure 12.18.
12.19.Disconnect the front of the actuator:
See Figure 12.19.
• Remove the hairpin clip from the clevis pin that
secures the front of the actuator to the frame.
• Hold the actuator to keep it from rotating.
• Lift the clevis pin up, releasing the actuator.
12.20.Carefully slide the actuator toward the back of
the mower to release it from the front bracket,
and lower it to remove it.
12.21.If the cables need to be replaced, remove them
as described in the following steps:
NOTE: Cable replacement can be accomplished
without removing the cable bracket assembly.
12.22.Remove the jam nuts from the end of each cable
using a 7/16” wrench and a 3/8” wrench.
See Figure 12.22.
Figure 12.16
Tape to temporarily secure carriage bolts
Figure 12.18
Cable bracket assembly
Figure 12.19
Removing clevis pin
Figure 12.22
Jam nuts