Cub Cadet Z-Wing - Manual (Page 26)

Cub Cadet Commercial Z-Wing
22
11.9. Assembly notes: See Figure 11.9.
• Reverse the disassembly process to install the
cable bracket: hook the long arm of the torsion
spring under the machine screw on the deck
wing hinge, and position the socket head cap
screw under the hinge lock.
• Lubricate the pivot point with anti-size com-
pound.
• Insert the bushing, and secure the assembly
with nut and bolt.
• Apply a small amount of thread locking com-
pound such as Loctite 242 (blue), or replace the
nut if the locking feature of the nut is in question.
Tighten the nut to a torque of 20-25 ft-lbs (27-34
Nm).
• Confirm correct operation and adjustment of the
wing lift mechanism and all associated safety
features before returning the mower to service.
11.10. To remove the hinge lock, the compression
spring that holds the hinge lock against the
bracket on the deck wing must first be discon-
nected. See Figure 11.10.
11.11. Remove the nut that secures bolt, flat washer,
and the compression spring using a pair of 9/16”
wrenches.
11.12. The shoulder bolt, spring, and flat washers can
all be removed if the spring is compressed with
finger pressure. See Figure 11.12.
Figure 11.9
Figure 11.10
Spring
Flat
washers
Nut
Figure 11.12