Cub Cadet Z-Wing - Manual (Page 31)

Cub Cadet Commercial Z-Wing
27
12.23.With the jam nuts removed, the threaded end of
the cable housings will pass through the key-
hole shaped slots in the end to the cable
bracket.
12.24.With the cables free of the cable bracket, the
actuator mounting bracket can be rolled out the
end of the cable bracket. See Figure 12.24.
12.25.To separate Z-fittings on the end of the cables
from the actuator mounting bracket, remove one
of the vertical-axis rollers, and loosen the sec-
ond one using a 1/2” wrench and a 3/16” allen
wrench. This will allow the cable retainer to
pivot, releasing the Z-fittings from the actuator
mounting bracket. See Figure 12.25.
Figure 12.24
Actuator mounting bracket
Cable bracket
Figure 12.25
Vertical axis rollers
Cable
Retainer
12.26.While the cable bracket and actuator mounting
bracket are disassembled, inspect the rollers
and their mounting hardware. See Figure 12.26.
NOTE: To judge the amount of wear on the roll-
ers, the new measurements are as follows:
O.D.= .880”, I.D.= .375”, Thickness= .283”
(O.D.= 2.24cm, I.D.= .95cm, Thickness= .72cm)
NOTE: The 4 horizontal-axis rollers can be
removed in similar fashion, but there is a washer
between each roller and the actuator bracket.
12.27.On mowers produced after November of 2005,
the cable bracket assembly was changed. The
bottom lip of the current brackets flares outward,
while the earlier ones are bent in.
See Figure 12.27.
Figure 12.26
Shoulder bolt
Roller
Washers
(horizontal axis
rollers only)
Figure 12.27