Panasonic KX-F3100 - Manual (Page 165)

Selecting the Number of Rings in the ANS/FAX Mode
When receiving a cal! in the ANS/FAX mode, the unit will automatically answer on the first ring
as a pre-selected setting.
If you wish to change the number of rings to answer a call, you can choose among the following:
0: Toll Saver (see page 164)
1: The unit answers on the first ring (pre-selected setting).
2: The unit answers on the second ring.
3: The unit answers on the third ring.
4: The unit answers on the fourth ring.
* :The unit will not ring. (RINGER OFF)
HELPFUL HINTS:
- If you wish to have the opportunity to pick up the handset before the call is answered by the
unit, increase the number of rings.
- If there is difficulty in receiving faxes from machines that have an automatic transmission
feature, decrease the number of rings.
- To confirm from a remote phone whether a new incoming message has been recorded or not,
select “0” (Toll Saver). This will save you the toll charge for the call.
- If you lose your instructions while programming, press the HELP button. The unit will print
information on how to program.
To change the number of rings in the ANS/FAX mode, proceed as follows:
Press MENU until the following is shown.
1
2
j
CHI ^
1! I «c 2| IMF 3| Q
•AUSE
O
8
EES CIS o
PROG.[1.DATE 2.TEL
3.SYSTEM 4.REPORT]
Press #, then press 07 to start programming.
ANS/FAX RING
COUNT=l [0-4,:.]
3 Enter the number of the selection you desire.
Setting selections are:
0: Toll Saver
1: one ring
2: two rings
3: three rings
4: four rings
*: RINGER OFF
163