Cabletron Systems 2M46-04R - Manual (Page 98)

Chapter 5: Local Management
5-50 2M46-04R/2M46-04RDC User’s Guide
Reboot After Download (Modifiable when RUNTIME is chosen only)
This field notifies the user that the 2M46-04R will reboot after the
download is complete. If a Runtime Download is performed, this field
toggles between YES and NO. If YES is selected, the device reboots after
the download is completed. If NO is selected, the device continues using
the existing firmware image and stores the new firmware image in
FLASH memory. When the device is reset or during the next power-up,
the device will boot from FLASH memory using the new image.
TFTP Gateway IP Addr (Selectable)
This field shows the IP address of the TFTP gateway defined in the
General Configuration screen in
Section 5.7.4 .
Last Image Server IP (Read-only)
This field shows the IP address of the server used for the previous FLASH
Download.
Last Image File Name (Read-only)
This field shows the complete path and file name of the last image
downloaded to FLASH.
If TFTP or RUNTIME is selected as the download method ( Figure 5-20 ),
the following two additional fields appear:
Download Server IP (Modifiable)
The IP address of the TFTP server to be used for the FLASH download is
entered in this field.
Download File Name (Modifiable)
The complete TFTP Server path and file name of the new image is entered
in this field.
5.15.1 Image File Download Using BootP
To download a firmware image into FLASH using BootP, proceed as
follows:
1. Use the arrow keys to highlight the Download Method field.
2. Use the SPACE bar to select BOOTP.
3. Use the arrow keys to highlight the TFTP Gateway IP Addr field.