Cabletron Systems 2M46-04R - Manual (Page 77)

SNMP Community Names Screen
2M46-04R/2M46-04RDC User’s Guide 5-29
5.7.12 Enabling/Disabling IP Fragmentation
To enable or disable IP fragmentation, proceed as follows:
1. Use the arrow keys to highlight the IP Fragmentation field.
2. Press the SPACE bar to choose either ENABLED or DISABLED.
3. Use the arrow keys to highlight the SAVE command.
4. Press ENTER. “SAVED OK” displays in the Event Message Line at
the top of the screen.
5.8 SNMP COMMUNITY NAMES SCREEN
The SNMP Community Names option allows the user to set SNMP
Management community names. Community names act as passwords to
Local/Remote Management and are agents of security access to the
2M46-04R. Access to the 2M46-04R is controlled by enacting any of
three different levels of security authorization (read-only, read-write, and
super-user).
To access the SNMP Community Names screen from the Device
Configuration Menu screen, use the arrow keys to highlight the SNMP
COMMUNITY NAMES menu item and press ENTER. The SNMP
Community Names screen displays.
!
CAUTION
If the 2M46-04R is being bridged to an FDDI ring via an
optional HSIM-F6, IP Fragmentation should be enabled. If IP
Fragmentation is disabled, all FDDI frames that exceed the
maximum Ethernet frame size will be discarded.
NOTE
Super-user access gives the user full management privileges,
allows existing passwords to be changed, and all modifiable
MIB objects for the Cabletron Container MIB and Internet
MIB-II to be edited.