Cabletron Systems 2M46-04R - Manual (Page 56)

Chapter 5: Local Management
5-8 2M46-04R/2M46-04RDC User’s Guide
5.4 ACCESSING LOCAL MANAGEMENT
Access to Local Management is controlled through the Password screen
shown in
Figure 5-3 . Whenever a connection is made to the 2M46-04R
the Password screen displays. Before continuing, the user must enter a
password (community name) which is compared to the previously stored
passwords. The level of access allowed the user depends on the password.
To set or change passwords refer to
Section 5.8 . The following steps
describe the procedure to access Local Management.
1. Turn on the terminal. Press ENTER (up to four times) until the
2M46-04R Local Management Password screen displays (
Figure 5-3 ).
Figure 5-3 Local Management Password Screen
2. Enter the Password and press ENTER. The default super-user access
password is “public” or press ENTER.
NOTE
The user’s password is one of the community names specified
in the SNMP Community Names screen. Access to certain
Local Management capabilities depends on the degree of
access accorded that community name. Refer to
Section 5.8 .
2M46-04R LOCAL MANAGEMENT
CABLETRON Systems, Incorporated
P.O.Box 5005
Rochester, NH 03866-5005 USA
(603) 332-9400
(c) Copyright CABLETRON Systems, Inc, 1997
Device Serial Number: XXXXXXXXX
Device Hardware Revision: XX
Device Firmware Revision: X.XX.XX
Device BOOTPROM Revision: X.XX.XX
Enter Password:
2314-12
Event Message Line