Cabletron Systems 2M46-04R - Manual (Page 76)

Chapter 5: Local Management
5-28 2M46-04R/2M46-04RDC User’s Guide
5.7.11 Clearing NVRAM
Clearing NVRAM allows the user to clear all user-entered parameters,
such as, the IP address and Community Names from NVRAM.
Clear NVRAM as follows:
1. Use the arrow keys to highlight the Clear NVRAM field.
2. Use the SPACE bar to toggle the field to YES.
3. Use the arrow keys to highlight SAVE at the bottom of the screen.
4. Press ENTER. The warning shown in Figure 5-12 displays.
5. Use the arrow keys to highlight YES and press ENTER.The message
“CLEARING NVRAM. REBOOT IN PROGRESS...” displays.
The 2M46-04R clears NVRAM and reboots. All user-entered
parameters default to factory default settings.
Figure 5-12 Clear NVRAM Warning Screen
!
CAUTION
Clearing NVRAM will result in the loss of all user-entered
parameters. Do not proceed unless this procedure is
completely understood.
WARNING
174251
YOU HAVE ELECTED TO CLEAR NVRAM. THIS WILL CLEAR
ALL SYSTEM DEFAULTS INCLUDING BUT NOT LIMITED TO
IP ADDRESS, INTERFACE CONFIGURATION, AND COM PORT
CONFIGURATION, THEN REBOOT THIS DEVICE.
ARE YOU SURE YOU WANT TO CLEAR NVRAM?
YES NO