Cabletron Systems 2M46-04R - Manual (Page 30)

Chapter 3: Installation
3-6 2M46-04R/2M46-04RDC User’s Guide
Figure 3-3 Installing the Rackmount Brackets
3. With the mounting brackets installed, position the 2M46-04R between
the vertical frame members of the 19-inch rack and fasten it securely
with mounting screws as shown in
Figure 3-4 .
Figure 3-4 Installing the 2M46-04R in a Rack
Bonding the Rackmount Brackets to the 2M46-04RDC
If the 2M46-04RDC is going to be mounted in a rack and needs to meet
the GR-1089-CORE Section 9 bonding requirements, use the following
instructions to install the 2M46-04RDC into a 19-inch rack.
1. Remove and discard the four cover screws (two from each side)
located along the front edges of each side of the 2M46-04RDC.
2. Remove the paint from around the area near the mounting holes on the
left and right side of the cover of the 2M46-04RDC. See
Figure 3-5 .
3. Apply a thin layer of anti-oxidant to the surface where the paint was
removed.
Screws (4)
Rackmount Brackets (2)
2314-04
2M46-04R 2 1
HSIM 1 HSIM 2
RESET COM
PWR
CPU
Screws (4)
19-Inch Rack
HSIM 1 HSIM 2
RESET COM
2314-03
2M46-04R 2 1
PWR
CPU