Cabletron Systems 2M46-04R - Manual (Page 82)

Chapter 5: Local Management
5-34 2M46-04R/2M46-04RDC User’s Guide
5.10 SWITCH CONFIGURATION SCREEN
The Switch Configuration screen, Figure 5-15 , provides the basic setup
options to make a switch operational in your network.
To access the Switch Configuration screen from the Device Configuration
Menu screen, use the arrow keys to highlight the SWITCH
CONFIGURATION menu item and press ENTER. The Switch
Configuration screen displays.
Figure 5-15 Switch Configuration Screen
NOTE
The Switch Configuration screen will only display if the
operational mode of the device has been set to 802.1D
SWITCHING or 802.1Q SWITCHING. Refer to
Section 5.7.9
for instructions on configuring the device to operate in this
mode.
NOTE
Ports 1 and 2 of the Switch Configuration screen correspond to
the Fast Ethernet slots and ports 3 and 4 correspond to the
HSIM slots.
Firmware Revision: XX.XX.XX
Switch Configuration
2314-18
Device Type: 2M46-04R
BOOTPROM Revision: XX.XX.XX
Port #
1
2
3
4
State
learning
listening
blocking
disabled
2M46-04R LOCAL MANAGEMENT
Event Message Line
RETURN SAVE
MAC Address
00-00-1D-00-00-00
00-00-1D-00-00-01
00-00-1D-00-00-02
Status
[ENABLED]
[ENABLED]
[ENABLED]
[DISABLED]
Switch Address: 00-00-1D-00-00-00
Number of Ports: 4 Type of STA: [IEEE]
Age Time (sec): 300
EXIT